We may earn a commission if you buy through these links. It never changes a verdict. How this works
Find my setup

Will the BLUETTI PV120 Solar Panel work with the Jackery Explorer 1000?

Yes. One BLUETTI PV120 Solar Panel works with the Jackery Explorer 1000: about 26.7 V on a 20°F morning against the station's 30 V limit, and about 120 W in full sun. Two panels: works (2 panels in parallel on DC input), about 147 W.

Verdict

Works

1 x PV120 Solar Panel into the Explorer 1000 (1 panel on DC input) stays inside 12 to 30 V and under 7.5 A, even at 20F.

1 x PV120 Solar Panel1 panel on DC input
Explorer 1000DC input
Expected
120W
Voltage at 20F
26.7V
limit 30 V
Current
6.1A
cap 7.5 A
  • The brand does not say whether its voltage limit is open-circuit or working voltage, so we check against the stricter open-circuit number.
Cables to buy
  • Use the solar charging cable that came with the station (MC4 on the panel side).
BLUETTI PV120 Solar Panel

120 W, open-circuit 24.4 V, short-circuit 6.4 A, working 19.6 V / 6.1 A. Brand page Panel details

Jackery Explorer 1000

Solar input DC input: 12 to 30 V. Brand page Station details

Change the count or temperature

Two panels: every way to wire them

WiringInputVolts at 20FAmpsWattsVerdict
2 panels in parallel on DC input
The brand does not say whether its voltage limit is open-circuit or working voltage, so we check against the stricter open-circuit number.
DC input26.712.2147Works
2 panels in series on DC input
Open-circuit voltage 48.8V is above the station's 30V limit. Going over a station's input voltage limit can damage it.
DC input53.46.10Don't connect

Quick answers

Will the BLUETTI PV120 Solar Panel work with the Jackery Explorer 1000?

Yes. One BLUETTI PV120 Solar Panel works with the Jackery Explorer 1000: about 26.7 V on a 20°F morning against the station's 30 V limit, and about 120 W in full sun. Two panels: works (2 panels in parallel on DC input), about 147 W.

Can I connect two PV120 Solar Panel panels to the Explorer 1000?

Yes, 2 panels in parallel on DC input. That gives about 147 W.

What cable do I need to connect the PV120 Solar Panel to the Explorer 1000?

Use the solar charging cable that came with the station (MC4 on the panel side).

Is it safe on a cold morning?

Panel voltage rises in the cold. One PV120 Solar Panel goes from 24.4 V on its label to about 26.7 V at 20°F and 27.5 V at 0°F. The Explorer 1000 accepts up to 30 V on the DC input.

Where to buy

Out of stock at the BLUETTI store
View at store
$999 at the Jackery store, Oct 28, 2026
BuyAmazon

We may earn a commission if you buy through these links. It never changes a verdict.

Other panels that work with the Explorer 1000

→BLUETTI SP200L Solar Panel, about 400 W with two
→EcoFlow 175W Rigid Solar Panel, about 167 W with two
→Anker SOLIX PS100 Bifacial, about 162 W with two
→BLUETTI SP100L Solar Panel, about 154 W with two
→BLUETTI PV200D, about 153 W with two

All 33 panels checked against the Explorer 1000

Rules we applied
  • Jackery Explorer 1000: solar input 12 to 30 V on the Solar in (DC input). Jackery does not say whether this limit is open-circuit or working voltage, so we use the stricter reading: open-circuit voltage on your coldest morning.
  • Cold raises panel voltage: we add 0.30% per °C below 77F (25°C), a typical figure, since this panel does not publish its own. At 20F one panel's 24.4 V becomes 26.7 V.
  • Current over the 7.5 A cap is safe: the station takes 7.5 A and you get fewer watts. We count only the capped watts.
  • Max watts on this input: not confirmed yet.
Assumptions
  • Cold-morning voltage uses 0.30% per °C, typical for crystalline panels. This panel's own value is not published.
  • Expected watts are the best case in full sun. Real-world midday output is usually 60 to 80% of that.
Sources
From the brand's pagePV120 Solar Panel label values
Checked Oct 28, 2026