Will the EcoFlow 175W Rigid Solar Panel work with the Jackery Explorer 1000?
Yes. One EcoFlow 175W Rigid Solar Panel works with the Jackery Explorer 1000: about 27.9 V on a 20°F morning against the station's 30 V limit, and about 167 W in full sun. Two panels: works (2 panels in parallel on DC input), about 167 W.
Works
1 x 175W Rigid Solar Panel into the Explorer 1000 (1 panel on DC input) stays inside 12 to 30 V, even at 20F. The station caps the current at 7.5 A.
- The brand does not say whether its voltage limit is open-circuit or working voltage, so we check against the stricter open-circuit number.
- The panels can push 7.9A but this input takes 7.5A, so the station caps it. Safe, you just lose some watts.
- EcoFlow's spec table labels the 7.85 A figure as a voltage; it is the operating current.
- Use the solar charging cable that came with the station (MC4 on the panel side).
175 W, open-circuit 25.5 V, short-circuit 8.3 A, working 22.3 V / 7.9 A. Brand page Panel details
Jackery Explorer 1000Solar input DC input: 12 to 30 V. Brand page Station details
Change the count or temperatureTwo panels: every way to wire them
| Wiring | Input | Volts at 20F | Amps | Watts | Verdict |
|---|---|---|---|---|---|
| 2 panels in parallel on DC input The brand does not say whether its voltage limit is open-circuit or working voltage, so we check against the stricter open-circuit number. | DC input | 27.9 | 15.7 | 167 | Works |
| 2 panels in series on DC input Open-circuit voltage 51V is above the station's 30V limit. Going over a station's input voltage limit can damage it. | DC input | 55.8 | 7.9 | 0 | Don't connect |
Quick answers
Will the EcoFlow 175W Rigid Solar Panel work with the Jackery Explorer 1000?
Yes. One EcoFlow 175W Rigid Solar Panel works with the Jackery Explorer 1000: about 27.9 V on a 20°F morning against the station's 30 V limit, and about 167 W in full sun. Two panels: works (2 panels in parallel on DC input), about 167 W.
Can I connect two 175W Rigid Solar Panel panels to the Explorer 1000?
Yes, 2 panels in parallel on DC input. That gives about 167 W.
What cable do I need to connect the 175W Rigid Solar Panel to the Explorer 1000?
Use the solar charging cable that came with the station (MC4 on the panel side).
Is it safe on a cold morning?
Panel voltage rises in the cold. One 175W Rigid Solar Panel goes from 25.5 V on its label to about 27.9 V at 20°F and 28.8 V at 0°F. The Explorer 1000 accepts up to 30 V on the DC input.
Where to buy
We may earn a commission if you buy through these links. It never changes a verdict.
Other panels that work with the Explorer 1000
- Jackery Explorer 1000: solar input 12 to 30 V on the Solar in (DC input). Jackery does not say whether this limit is open-circuit or working voltage, so we use the stricter reading: open-circuit voltage on your coldest morning.
- Cold raises panel voltage: we add 0.30% per °C below 77F (25°C), a typical figure, since this panel does not publish its own. At 20F one panel's 25.5 V becomes 27.9 V.
- Current over the 7.5 A cap is safe: the station takes 7.5 A and you get fewer watts. We count only the capped watts.
- Max watts on this input: not confirmed yet.
- Cold-morning voltage uses 0.30% per °C, typical for crystalline panels. This panel's own value is not published.
- Expected watts are the best case in full sun. Real-world midday output is usually 60 to 80% of that.