Will the Renogy 100W Lightweight Flexible Solar Panel work with the Jackery Explorer 100 Plus?
Yes. One Renogy 100W Lightweight Flexible Solar Panel works with the Jackery Explorer 100 Plus: about 24.6 V on a 20°F morning against the station's 27.2 V limit, and about 95 W in full sun. Two panels: works (2 panels in parallel on USB-C), about 95 W.
Works
1 x 100W Lightweight Flexible Solar Panel into the Explorer 100 Plus (1 panel on USB-C) stays inside 18 to 27.2 V, even at 20F. The station caps the current at 5 A.
- The brand does not say whether its voltage limit is open-circuit or working voltage, so we check against the stricter open-circuit number.
- The panels can push 5.3A but this input takes 5A, so the station caps it. Safe, you just lose some watts.
- Solar charging goes in through the USB-C port (18 to 27.2V, 100W max).
- Solar goes in through the USB-C port, using the DC7909-to-USB-C adaptor that comes with the station.
100 W, open-circuit 22.5 V, short-circuit 5.8 A, working 18.9 V / 5.3 A. Brand page Panel details
Jackery Explorer 100 PlusSolar input USB-C: 18 to 27.2 V, 100 W max. Manual Station details
Change the count or temperatureTwo panels: every way to wire them
| Wiring | Input | Volts at 20F | Amps | Watts | Verdict |
|---|---|---|---|---|---|
| 2 panels in parallel on USB-C The brand does not say whether its voltage limit is open-circuit or working voltage, so we check against the stricter open-circuit number. | USB-C | 24.6 | 10.6 | 95 | Works |
| 2 panels in series on USB-C Open-circuit voltage 45V is above the station's 27.2V limit. Going over a station's input voltage limit can damage it. | USB-C | 49.3 | 5.3 | 0 | Don't connect |
Quick answers
Will the Renogy 100W Lightweight Flexible Solar Panel work with the Jackery Explorer 100 Plus?
Yes. One Renogy 100W Lightweight Flexible Solar Panel works with the Jackery Explorer 100 Plus: about 24.6 V on a 20°F morning against the station's 27.2 V limit, and about 95 W in full sun. Two panels: works (2 panels in parallel on USB-C), about 95 W.
Can I connect two 100W Lightweight Flexible Solar Panel panels to the Explorer 100 Plus?
Yes, 2 panels in parallel on USB-C. That gives about 95 W.
What cable do I need to connect the 100W Lightweight Flexible Solar Panel to the Explorer 100 Plus?
Solar goes in through the USB-C port, using the DC7909-to-USB-C adaptor that comes with the station.
Is it safe on a cold morning?
Panel voltage rises in the cold. One 100W Lightweight Flexible Solar Panel goes from 22.5 V on its label to about 24.6 V at 20°F and 25.4 V at 0°F. The Explorer 100 Plus accepts up to 27.2 V on the USB-C.
Where to buy
We may earn a commission if you buy through these links. It never changes a verdict.
Other panels that work with the Explorer 100 Plus
- Jackery Explorer 100 Plus: solar input 18 to 27.2 V on the Solar in (USB-C). Jackery does not say whether this limit is open-circuit or working voltage, so we use the stricter reading: open-circuit voltage on your coldest morning.
- Cold raises panel voltage: we add 0.30% per °C below 77F (25°C), a typical figure, since this panel does not publish its own. At 20F one panel's 22.5 V becomes 24.6 V.
- Current over the 5 A cap is safe: the station takes 5 A and you get fewer watts. We count only the capped watts.
- Max 100 W on this input.
- Cold-morning voltage uses 0.30% per °C, typical for crystalline panels. This panel's own value is not published.
- Expected watts are the best case in full sun. Real-world midday output is usually 60 to 80% of that.