Will the BLUETTI PV120 Solar Panel work with the Jackery Explorer 100 Plus?
Yes. One BLUETTI PV120 Solar Panel works with the Jackery Explorer 100 Plus: about 26.7 V on a 20°F morning against the station's 27.2 V limit, and about 98 W in full sun. Two panels: works (2 panels in parallel on USB-C), about 98 W.
Works
1 x PV120 Solar Panel into the Explorer 100 Plus (1 panel on USB-C) stays inside 18 to 27.2 V, even at 20F. The station caps the current at 5 A.
- The brand does not say whether its voltage limit is open-circuit or working voltage, so we check against the stricter open-circuit number.
- The panels can push 6.1A but this input takes 5A, so the station caps it. Safe, you just lose some watts.
- Solar charging goes in through the USB-C port (18 to 27.2V, 100W max).
- Solar goes in through the USB-C port with a DC8020-to-USB-C adapter cable, sold separately; an MC4 panel also needs an MC4-to-DC8020 adapter in front of it.
120 W, open-circuit 24.4 V, short-circuit 6.4 A, working 19.6 V / 6.1 A. Brand page Panel details
Jackery Explorer 100 PlusSolar input USB-C: 18 to 27.2 V, 100 W max. Manual Station details
Change the count or temperatureTwo panels: every way to wire them
| Wiring | Input | Volts at 20F | Amps | Watts | Verdict |
|---|---|---|---|---|---|
| 2 panels in parallel on USB-C The brand does not say whether its voltage limit is open-circuit or working voltage, so we check against the stricter open-circuit number. | USB-C | 26.7 | 12.2 | 98 | Works |
| 2 panels in series on USB-C Open-circuit voltage 48.8V is above the station's 27.2V limit. Going over a station's input voltage limit can damage it. | USB-C | 53.4 | 6.1 | 0 | Don't connect |
Quick answers
Will the BLUETTI PV120 Solar Panel work with the Jackery Explorer 100 Plus?
Yes. One BLUETTI PV120 Solar Panel works with the Jackery Explorer 100 Plus: about 26.7 V on a 20°F morning against the station's 27.2 V limit, and about 98 W in full sun. Two panels: works (2 panels in parallel on USB-C), about 98 W.
Can I connect two PV120 Solar Panel panels to the Explorer 100 Plus?
Yes, 2 panels in parallel on USB-C. That gives about 98 W.
What cable do I need to connect the PV120 Solar Panel to the Explorer 100 Plus?
Solar goes in through the USB-C port with a DC8020-to-USB-C adapter cable, sold separately; an MC4 panel also needs an MC4-to-DC8020 adapter in front of it.
Is it safe on a cold morning?
Panel voltage rises in the cold. One PV120 Solar Panel goes from 24.4 V on its label to about 26.7 V at 20°F and 27.5 V at 0°F. The Explorer 100 Plus accepts up to 27.2 V on the USB-C.
Where to buy
We may earn a commission if you buy through these links. It never changes a verdict.
Other panels that work with the Explorer 100 Plus
- Jackery Explorer 100 Plus: solar input 18 to 27.2 V on the Solar in (USB-C). Jackery does not say whether this limit is open-circuit or working voltage, so we use the stricter reading: open-circuit voltage on your coldest morning.
- Cold raises panel voltage: we add 0.30% per °C below 77F (25°C), a typical figure, since this panel does not publish its own. At 20F one panel's 24.4 V becomes 26.7 V.
- Current over the 5 A cap is safe: the station takes 5 A and you get fewer watts. We count only the capped watts.
- Max 100 W on this input.
- Cold-morning voltage uses 0.30% per °C, typical for crystalline panels. This panel's own value is not published.
- Expected watts are the best case in full sun. Real-world midday output is usually 60 to 80% of that.