Will the BLUETTI SP200L Solar Panel work with the BLUETTI EP500?
No. Open-circuit voltage 24.6V is below the 55V minimum for this input, so it will not start charging. Two panels: don't connect (2 panels in parallel on PV input), about 0 W.
Don't connect
Do not plug this in. Open-circuit voltage 24.6V is below the 55V minimum for this input, so it will not start charging.
- Open-circuit voltage 24.6V is below the 55V minimum for this input, so it will not start charging.
- BLUETTI does not publish the working voltage (Vmp) or current (Imp) for this panel.
200 W, open-circuit 24.6 V, short-circuit 10.8 A. Brand page Panel details
BLUETTI EP500Solar input PV input: 55 to 145 V, 1200 W max. Brand page Station details
Change the count or temperatureTwo panels: every way to wire them
| Wiring | Input | Volts at 20F | Amps | Watts | Verdict |
|---|---|---|---|---|---|
| 2 panels in parallel on PV input Open-circuit voltage 24.6V is below the 55V minimum for this input, so it will not start charging. | PV input | 26.9 | 21.6 | 0 | Don't connect |
| 2 panels in series on PV input Open-circuit voltage 49.2V is below the 55V minimum for this input, so it will not start charging. | PV input | 53.9 | 10.8 | 0 | Don't connect |
Quick answers
Will the BLUETTI SP200L Solar Panel work with the BLUETTI EP500?
No. Open-circuit voltage 24.6V is below the 55V minimum for this input, so it will not start charging. Two panels: don't connect (2 panels in parallel on PV input), about 0 W.
Can I connect two SP200L Solar Panel panels to the EP500?
No: Open-circuit voltage 24.6V is below the 55V minimum for this input, so it will not start charging.
Is it safe on a cold morning?
Panel voltage rises in the cold. One SP200L Solar Panel goes from 24.6 V on its label to about 26.9 V at 20°F and 27.8 V at 0°F. The EP500 accepts up to 145 V on the PV input.
Where to buy
We may earn a commission if you buy through these links. It never changes a verdict.
- BLUETTI EP500: solar input 55 to 145 V on the Solar in (PV input). BLUETTI sets this limit on open-circuit voltage (Voc), so we hold the panels' Voc on your coldest morning to it.
- Cold raises panel voltage: we add 0.30% per °C below 77F (25°C), a typical figure, since this panel does not publish its own. At 20F one panel's 24.6 V becomes 26.9 V.
- Current over the 20 A cap is safe: the station takes 20 A and you get fewer watts. We count only the capped watts.
- Max 1,200 W on this input.
- Cold-morning voltage uses 0.30% per °C, typical for crystalline panels. This panel's own value is not published.
- Expected watts are the best case in full sun. Real-world midday output is usually 60 to 80% of that.