Will the Jackery SolarSaga 100 Air work with the Anker SOLIX F3800 Plus?
Yes. One Jackery SolarSaga 100 Air works with the Anker SOLIX F3800 Plus: about 32.5 V on a 20°F morning against the station's 165 V limit, and about 100 W in full sun. Two panels: works (1 panel on Solar input + 1 panel on Solar input), about 200 W.
Works
1 x SolarSaga 100 Air into the F3800 Plus (1 panel on Solar input) stays inside 11 to 165 V and under 17 A, even at 20F.
- The brand does not say whether its voltage limit is open-circuit or working voltage, so we check against the stricter open-circuit number.
- Anker does not say whether its voltage limit is open-circuit or working voltage, so the checker uses the stricter reading.
- Anker's page: going over 165V can damage the solar input ports.
- Bifacial: Jackery also rates it at 110 W with light on the back (BNPI); the checker uses the front-only figures.
- Use the solar charging cable that came with the station (MC4 on the panel side).
100 W, open-circuit 29.7 V, short-circuit 4.1 A, working 25.4 V / 4 A. Brand page Panel details
Anker SOLIX F3800 PlusSolar input Solar input: 11 to 165 V; Solar input: 11 to 165 V, 3200 W max. Brand page Station details
Change the count or temperatureTwo panels: every way to wire them
| Wiring | Input | Volts at 20F | Amps | Watts | Verdict |
|---|---|---|---|---|---|
| 1 panel on Solar input + 1 panel on Solar input The brand does not say whether its voltage limit is open-circuit or working voltage, so we check against the stricter open-circuit number. | Solar input + Solar input | 32.5 | 4 | 200 | Works |
| 2 panels in parallel on Solar input The brand does not say whether its voltage limit is open-circuit or working voltage, so we check against the stricter open-circuit number. | Solar input | 32.5 | 7.9 | 200 | Works |
| 2 panels in series on Solar input The brand does not say whether its voltage limit is open-circuit or working voltage, so we check against the stricter open-circuit number. | Solar input | 65 | 4 | 200 | Works |
Quick answers
Will the Jackery SolarSaga 100 Air work with the Anker SOLIX F3800 Plus?
Yes. One Jackery SolarSaga 100 Air works with the Anker SOLIX F3800 Plus: about 32.5 V on a 20°F morning against the station's 165 V limit, and about 100 W in full sun. Two panels: works (1 panel on Solar input + 1 panel on Solar input), about 200 W.
Can I connect two SolarSaga 100 Air panels to the F3800 Plus?
Yes, 1 panel on Solar input + 1 panel on Solar input. That gives about 200 W.
What cable do I need to connect the SolarSaga 100 Air to the F3800 Plus?
Use the solar charging cable that came with the station (MC4 on the panel side).
Is it safe on a cold morning?
Panel voltage rises in the cold. One SolarSaga 100 Air goes from 29.7 V on its label to about 32.5 V at 20°F and 33.5 V at 0°F. The F3800 Plus accepts up to 165 V on the Solar input.
Where to buy
We may earn a commission if you buy through these links. It never changes a verdict.
Other panels that work with the F3800 Plus
- Anker SOLIX F3800 Plus: solar input 11 to 165 V on the Solar in 1 (Solar input). Anker SOLIX does not say whether this limit is open-circuit or working voltage, so we use the stricter reading: open-circuit voltage on your coldest morning.
- Cold raises panel voltage: we add 0.30% per °C below 77F (25°C), a typical figure, since this panel does not publish its own. At 20F one panel's 29.7 V becomes 32.5 V.
- Current over the 17 A cap is safe: the station takes 17 A and you get fewer watts. We count only the capped watts.
- Max 1,600 W on this input, 3,200 W across all inputs.
- Cold-morning voltage uses 0.30% per °C, typical for crystalline panels. This panel's own value is not published.
- Expected watts are the best case in full sun. Real-world midday output is usually 60 to 80% of that.