Will the Jackery SolarSaga 100 Air work with the Jackery Explorer 300D?
No. Open-circuit voltage 29.7V is above the station's 28V limit. Going over a station's input voltage limit can damage it. Two panels: don't connect (2 panels in parallel on DC8020), about 0 W.
Don't connect
Do not plug this in. Open-circuit voltage 29.7V is above the station's 28V limit. Going over a station's input voltage limit can damage it.
- Open-circuit voltage 29.7V is above the station's 28V limit. Going over a station's input voltage limit can damage it.
- Jackery's manual: the panel's open-circuit voltage (Voc) must be between 16 and 28V, 100W max.
- Bifacial: Jackery also rates it at 110 W with light on the back (BNPI); the checker uses the front-only figures.
100 W, open-circuit 29.7 V, short-circuit 4.1 A, working 25.4 V / 4 A. Brand page Panel details
Jackery Explorer 300DSolar input DC8020: 16 to 28 V, 100 W max. Manual Station details
Change the count or temperatureTwo panels: every way to wire them
| Wiring | Input | Volts at 20F | Amps | Watts | Verdict |
|---|---|---|---|---|---|
| 2 panels in parallel on DC8020 Open-circuit voltage 29.7V is above the station's 28V limit. Going over a station's input voltage limit can damage it. | DC8020 | 32.5 | 7.9 | 0 | Don't connect |
| 2 panels in series on DC8020 Open-circuit voltage 59.4V is above the station's 28V limit. Going over a station's input voltage limit can damage it. | DC8020 | 65 | 4 | 0 | Don't connect |
Quick answers
Will the Jackery SolarSaga 100 Air work with the Jackery Explorer 300D?
No. Open-circuit voltage 29.7V is above the station's 28V limit. Going over a station's input voltage limit can damage it. Two panels: don't connect (2 panels in parallel on DC8020), about 0 W.
Can I connect two SolarSaga 100 Air panels to the Explorer 300D?
No: Open-circuit voltage 29.7V is above the station's 28V limit. Going over a station's input voltage limit can damage it.
Is it safe on a cold morning?
Panel voltage rises in the cold. One SolarSaga 100 Air goes from 29.7 V on its label to about 32.5 V at 20°F and 33.5 V at 0°F. The Explorer 300D accepts up to 28 V on the DC8020.
Where to buy
We may earn a commission if you buy through these links. It never changes a verdict.
Other panels that work with the Explorer 300D
- Jackery Explorer 300D: solar input 16 to 28 V on the Solar in (DC8020). Jackery sets this limit on open-circuit voltage (Voc), so we hold the panels' Voc on your coldest morning to it.
- Cold raises panel voltage: we add 0.30% per °C below 77F (25°C), a typical figure, since this panel does not publish its own. At 20F one panel's 29.7 V becomes 32.5 V.
- Current over the 6 A cap is safe: the station takes 6 A and you get fewer watts. We count only the capped watts.
- Max 100 W on this input.
- Cold-morning voltage uses 0.30% per °C, typical for crystalline panels. This panel's own value is not published.
- Expected watts are the best case in full sun. Real-world midday output is usually 60 to 80% of that.