Will the Renogy 100W Lightweight Flexible Solar Panel work with the Jackery Explorer 300 v2?
Yes. One Renogy 100W Lightweight Flexible Solar Panel works with the Jackery Explorer 300 v2: about 24.6 V on a 20°F morning against the station's 28 V limit, and about 100 W in full sun. Two panels: works (2 panels in parallel on DC8020), about 100 W.
Works
1 x 100W Lightweight Flexible Solar Panel into the Explorer 300 v2 (1 panel on DC8020) stays inside 16 to 28 V and under 6 A, even at 20F.
- Jackery's manual: the panel's open-circuit voltage (Voc) must be between 16 and 28V. One 100W panel plugs straight into the DC8020 port.
- Needs an MC4 to DC8020 adapter cable.
100 W, open-circuit 22.5 V, short-circuit 5.8 A, working 18.9 V / 5.3 A. Brand page Panel details
Jackery Explorer 300 v2Solar input DC8020: 16 to 28 V, 100 W max. Manual Station details
Change the count or temperatureTwo panels: every way to wire them
| Wiring | Input | Volts at 20F | Amps | Watts | Verdict |
|---|---|---|---|---|---|
| 2 panels in parallel on DC8020 The panels can push 10.6A but this input takes 6A, so the station caps it. Safe, you just lose some watts. | DC8020 | 24.6 | 10.6 | 100 | Works |
| 2 panels in series on DC8020 Open-circuit voltage 45V is above the station's 28V limit. Going over a station's input voltage limit can damage it. | DC8020 | 49.3 | 5.3 | 0 | Don't connect |
Quick answers
Will the Renogy 100W Lightweight Flexible Solar Panel work with the Jackery Explorer 300 v2?
Yes. One Renogy 100W Lightweight Flexible Solar Panel works with the Jackery Explorer 300 v2: about 24.6 V on a 20°F morning against the station's 28 V limit, and about 100 W in full sun. Two panels: works (2 panels in parallel on DC8020), about 100 W.
Can I connect two 100W Lightweight Flexible Solar Panel panels to the Explorer 300 v2?
Yes, 2 panels in parallel on DC8020. That gives about 100 W.
What cable do I need to connect the 100W Lightweight Flexible Solar Panel to the Explorer 300 v2?
Needs an MC4 to DC8020 adapter cable.
Is it safe on a cold morning?
Panel voltage rises in the cold. One 100W Lightweight Flexible Solar Panel goes from 22.5 V on its label to about 24.6 V at 20°F and 25.4 V at 0°F. The Explorer 300 v2 accepts up to 28 V on the DC8020.
Where to buy
We may earn a commission if you buy through these links. It never changes a verdict.
Other panels that work with the Explorer 300 v2
- Jackery Explorer 300 v2: solar input 16 to 28 V on the Solar in (DC8020). Jackery sets this limit on open-circuit voltage (Voc), so we hold the panels' Voc on your coldest morning to it.
- Cold raises panel voltage: we add 0.30% per °C below 77F (25°C), a typical figure, since this panel does not publish its own. At 20F one panel's 22.5 V becomes 24.6 V.
- Current over the 6 A cap is safe: the station takes 6 A and you get fewer watts. We count only the capped watts.
- Max 100 W on this input.
- Cold-morning voltage uses 0.30% per °C, typical for crystalline panels. This panel's own value is not published.
- Expected watts are the best case in full sun. Real-world midday output is usually 60 to 80% of that.