Will the BLUETTI SP100L Solar Panel work with the Jackery Explorer 300 v2?
Yes. One BLUETTI SP100L Solar Panel works with the Jackery Explorer 300 v2: about 27 V on a 20°F morning against the station's 28 V limit, and about 100 W in full sun. Two panels: works (2 panels in parallel on DC8020), about 100 W.
Works
1 x SP100L Solar Panel into the Explorer 300 v2 (1 panel on DC8020) stays inside 16 to 28 V and under 6 A, even at 20F.
- Jackery's manual: the panel's open-circuit voltage (Voc) must be between 16 and 28V. One 100W panel plugs straight into the DC8020 port.
- Needs an MC4 to DC8020 adapter cable.
100 W, open-circuit 24.6 V, short-circuit 5.1 A, working 20.5 V / 4.9 A. Manual Panel details
Jackery Explorer 300 v2Solar input DC8020: 16 to 28 V, 100 W max. Manual Station details
Change the count or temperatureTwo panels: every way to wire them
| Wiring | Input | Volts at 20F | Amps | Watts | Verdict |
|---|---|---|---|---|---|
| 2 panels in parallel on DC8020 The panels can push 9.8A but this input takes 6A, so the station caps it. Safe, you just lose some watts. | DC8020 | 27 | 9.8 | 100 | Works |
| 2 panels in series on DC8020 Open-circuit voltage 49.2V is above the station's 28V limit. Going over a station's input voltage limit can damage it. | DC8020 | 53.9 | 4.9 | 0 | Don't connect |
Quick answers
Will the BLUETTI SP100L Solar Panel work with the Jackery Explorer 300 v2?
Yes. One BLUETTI SP100L Solar Panel works with the Jackery Explorer 300 v2: about 27 V on a 20°F morning against the station's 28 V limit, and about 100 W in full sun. Two panels: works (2 panels in parallel on DC8020), about 100 W.
Can I connect two SP100L Solar Panel panels to the Explorer 300 v2?
Yes, 2 panels in parallel on DC8020. That gives about 100 W.
What cable do I need to connect the SP100L Solar Panel to the Explorer 300 v2?
Needs an MC4 to DC8020 adapter cable.
Is it safe on a cold morning?
Panel voltage rises in the cold. One SP100L Solar Panel goes from 24.6 V on its label to about 27 V at 20°F and 27.8 V at 0°F. The Explorer 300 v2 accepts up to 28 V on the DC8020.
Where to buy
We may earn a commission if you buy through these links. It never changes a verdict.
Other panels that work with the Explorer 300 v2
- Jackery Explorer 300 v2: solar input 16 to 28 V on the Solar in (DC8020). Jackery sets this limit on open-circuit voltage (Voc), so we hold the panels' Voc on your coldest morning to it.
- Cold raises panel voltage: we add 0.30% per °C below 77F (25°C), a typical figure, since this panel does not publish its own. At 20F one panel's 24.6 V becomes 27 V.
- Current over the 6 A cap is safe: the station takes 6 A and you get fewer watts. We count only the capped watts.
- Max 100 W on this input.
- Cold-morning voltage uses 0.30% per °C, typical for crystalline panels. This panel's own value is not published.
- Expected watts are the best case in full sun. Real-world midday output is usually 60 to 80% of that.