Will the BLUETTI PV120 Solar Panel work with the EcoFlow TRAIL 300 DC?
Yes. One BLUETTI PV120 Solar Panel works with the EcoFlow TRAIL 300 DC: about 26.7 V on a 20°F morning against the station's 30 V limit, and about 110 W in full sun. Two panels: works (2 panels in parallel on Solar/Car input (XT60)), about 110 W.
Works
1 x PV120 Solar Panel into the TRAIL 300 DC (1 panel on Solar/Car input (XT60)) stays inside 10 to 30 V and under 10 A, even at 20F.
- Keep the panel under 30 V: EcoFlow says a higher voltage can damage the station.
- Use an MC4 to XT60 solar cable.
120 W, open-circuit 24.4 V, short-circuit 6.4 A, working 19.6 V / 6.1 A. Brand page Panel details
EcoFlow TRAIL 300 DCSolar input Solar/Car input (XT60): 10 to 30 V, 110 W max. Manual Station details
Change the count or temperatureTwo panels: every way to wire them
| Wiring | Input | Volts at 20F | Amps | Watts | Verdict |
|---|---|---|---|---|---|
| 2 panels in parallel on Solar/Car input (XT60) The panels can push 12.2A but this input takes 10A, so the station caps it. Safe, you just lose some watts. | Solar/Car input (XT60) | 26.7 | 12.2 | 110 | Works |
| 2 panels in series on Solar/Car input (XT60) Open-circuit voltage 48.8V is above the station's 30V limit. Going over a station's input voltage limit can damage it. | Solar/Car input (XT60) | 53.4 | 6.1 | 0 | Don't connect |
Quick answers
Will the BLUETTI PV120 Solar Panel work with the EcoFlow TRAIL 300 DC?
Yes. One BLUETTI PV120 Solar Panel works with the EcoFlow TRAIL 300 DC: about 26.7 V on a 20°F morning against the station's 30 V limit, and about 110 W in full sun. Two panels: works (2 panels in parallel on Solar/Car input (XT60)), about 110 W.
Can I connect two PV120 Solar Panel panels to the TRAIL 300 DC?
Yes, 2 panels in parallel on Solar/Car input (XT60). That gives about 110 W.
What cable do I need to connect the PV120 Solar Panel to the TRAIL 300 DC?
Use an MC4 to XT60 solar cable.
Is it safe on a cold morning?
Panel voltage rises in the cold. One PV120 Solar Panel goes from 24.4 V on its label to about 26.7 V at 20°F and 27.5 V at 0°F. The TRAIL 300 DC accepts up to 30 V on the Solar/Car input (XT60).
Where to buy
We may earn a commission if you buy through these links. It never changes a verdict.
Other panels that work with the TRAIL 300 DC
- EcoFlow TRAIL 300 DC: solar input 10 to 30 V on the Solar in (Solar/Car input (XT60)). EcoFlow sets this limit on open-circuit voltage (Voc), so we hold the panels' Voc on your coldest morning to it.
- Cold raises panel voltage: we add 0.30% per °C below 77F (25°C), a typical figure, since this panel does not publish its own. At 20F one panel's 24.4 V becomes 26.7 V.
- Current over the 10 A cap is safe: the station takes 10 A and you get fewer watts. We count only the capped watts.
- Max 110 W on this input.
- Cold-morning voltage uses 0.30% per °C, typical for crystalline panels. This panel's own value is not published.
- Expected watts are the best case in full sun. Real-world midday output is usually 60 to 80% of that.