Will the BLUETTI PV350D work with the EcoFlow DELTA 3 Ultra Plus?
Yes. One BLUETTI PV350D works with the EcoFlow DELTA 3 Ultra Plus: about 36.1 V on a 20°F morning against the station's 60 V limit, and about 350 W in full sun. Two panels: works (1 panel on Solar input 1 (XT60i) + 1 panel on Solar input 2 (XT60i)), about 700 W.
Works
1 x PV350D into the DELTA 3 Ultra Plus (1 panel on Solar input 1 (XT60i)) stays inside 11 to 60 V and under 18 A, even at 20F.
- The panel's plug type is not confirmed yet. Check the label or the box before buying a cable.
350 W, open-circuit 33 V, short-circuit 13.8 A, working 27.6 V / 12.7 A. Manual Panel details
EcoFlow DELTA 3 Ultra PlusSolar input Solar input 1 (XT60i): 11 to 60 V; Solar input 2 (XT60i): 11 to 60 V, 1600 W max. Manual Station details
Change the count or temperatureTwo panels: every way to wire them
| Wiring | Input | Volts at 20F | Amps | Watts | Verdict |
|---|---|---|---|---|---|
| 1 panel on Solar input 1 (XT60i) + 1 panel on Solar input 2 (XT60i) Best option | Solar input 1 (XT60i) + Solar input 2 (XT60i) | 36.1 | 12.7 | 700 | Works |
| 2 panels in parallel on Solar input 1 (XT60i) The panels can push 25.4A but this input takes 18A, so the station caps it. Safe, you just lose some watts. | Solar input 1 (XT60i) | 36.1 | 25.4 | 497 | Works |
| 2 panels in parallel on Solar input 2 (XT60i) The panels can push 25.4A but this input takes 18A, so the station caps it. Safe, you just lose some watts. | Solar input 2 (XT60i) | 36.1 | 25.4 | 497 | Works |
| 2 panels in series on Solar input 1 (XT60i) Open-circuit voltage 66V is above the station's 60V limit. Going over a station's input voltage limit can damage it. | Solar input 1 (XT60i) | 72.3 | 12.7 | 0 | Don't connect |
| 2 panels in series on Solar input 2 (XT60i) Open-circuit voltage 66V is above the station's 60V limit. Going over a station's input voltage limit can damage it. | Solar input 2 (XT60i) | 72.3 | 12.7 | 0 | Don't connect |
Quick answers
Will the BLUETTI PV350D work with the EcoFlow DELTA 3 Ultra Plus?
Yes. One BLUETTI PV350D works with the EcoFlow DELTA 3 Ultra Plus: about 36.1 V on a 20°F morning against the station's 60 V limit, and about 350 W in full sun. Two panels: works (1 panel on Solar input 1 (XT60i) + 1 panel on Solar input 2 (XT60i)), about 700 W.
Can I connect two PV350D panels to the DELTA 3 Ultra Plus?
Yes, 1 panel on Solar input 1 (XT60i) + 1 panel on Solar input 2 (XT60i). That gives about 700 W.
What cable do I need to connect the PV350D to the DELTA 3 Ultra Plus?
The panel's plug type is not confirmed yet. Check the label or the box before buying a cable.
Is it safe on a cold morning?
Panel voltage rises in the cold. One PV350D goes from 33 V on its label to about 36.1 V at 20°F and 37.2 V at 0°F. The DELTA 3 Ultra Plus accepts up to 60 V on the Solar input 1 (XT60i).
Where to buy
We may earn a commission if you buy through these links. It never changes a verdict.
Other panels that work with the DELTA 3 Ultra Plus
- EcoFlow DELTA 3 Ultra Plus: solar input 11 to 60 V on the Solar in 1 (Solar input 1 (XT60i)). EcoFlow sets this limit on open-circuit voltage (Voc), so we hold the panels' Voc on your coldest morning to it.
- Cold raises panel voltage: we add 0.30% per °C below 77F (25°C), a typical figure, since this panel does not publish its own. At 20F one panel's 33 V becomes 36.1 V.
- Current over the 18 A cap is safe: the station takes 18 A and you get fewer watts. We count only the capped watts.
- Max 800 W on this input, 1,600 W across all inputs.
- Cold-morning voltage uses 0.30% per °C, typical for crystalline panels. This panel's own value is not published.
- Expected watts are the best case in full sun. Real-world midday output is usually 60 to 80% of that.