Will the Renogy 50W Mono N-Type Rigid Solar Panel work with the DJI Power 1000 Mini?
Yes. One Renogy 50W Mono N-Type Rigid Solar Panel works with the DJI Power 1000 Mini: about 24.4 V on a 20°F morning against the station's 28 V limit, and about 50 W in full sun. Two panels: works (2 panels in parallel on SDC (built-in MPPT, DJI MC4 solar cable)), about 100 W.
Works
1 x 50W Mono N-Type Rigid Solar Panel into the Power 1000 Mini (1 panel on SDC (built-in MPPT, DJI MC4 solar cable)) stays inside 9 to 28 V, even at 20F.
- The brand does not say whether its voltage limit is open-circuit or working voltage, so we check against the stricter open-circuit number.
- The manual or page does not give a current limit for this input, so current was not checked.
- The MPPT is built in: panels connect to the SDC port with the DJI Power MC4 Solar Power Charging Cable. DJI gives the port as 9 to 28 V and 400 W but publishes no current limit, so the checker checks voltage and watts but not current.
- Not sold on the DJI US online store when we checked on Oct 28, 2026.
- Use the solar charging cable that came with the station (MC4 on the panel side).
50 W, open-circuit 22.3 V, short-circuit 2.9 A, working 18.6 V / 2.7 A. Brand page Panel details
DJI Power 1000 MiniSolar input SDC (built-in MPPT, DJI MC4 solar cable): 9 to 28 V, 400 W max. Brand page Station details
Change the count or temperatureTwo panels: every way to wire them
| Wiring | Input | Volts at 20F | Amps | Watts | Verdict |
|---|---|---|---|---|---|
| 2 panels in parallel on SDC (built-in MPPT, DJI MC4 solar cable) The brand does not say whether its voltage limit is open-circuit or working voltage, so we check against the stricter open-circuit number. | SDC (built-in MPPT, DJI MC4 solar cable) | 24.4 | 5.4 | 100 | Works |
| 2 panels in series on SDC (built-in MPPT, DJI MC4 solar cable) Open-circuit voltage 44.6V is above the station's 28V limit. Going over a station's input voltage limit can damage it. | SDC (built-in MPPT, DJI MC4 solar cable) | 48.8 | 2.7 | 0 | Don't connect |
Quick answers
Will the Renogy 50W Mono N-Type Rigid Solar Panel work with the DJI Power 1000 Mini?
Yes. One Renogy 50W Mono N-Type Rigid Solar Panel works with the DJI Power 1000 Mini: about 24.4 V on a 20°F morning against the station's 28 V limit, and about 50 W in full sun. Two panels: works (2 panels in parallel on SDC (built-in MPPT, DJI MC4 solar cable)), about 100 W.
Can I connect two 50W Mono N-Type Rigid Solar Panel panels to the Power 1000 Mini?
Yes, 2 panels in parallel on SDC (built-in MPPT, DJI MC4 solar cable). That gives about 100 W.
What cable do I need to connect the 50W Mono N-Type Rigid Solar Panel to the Power 1000 Mini?
Use the solar charging cable that came with the station (MC4 on the panel side).
Is it safe on a cold morning?
Panel voltage rises in the cold. One 50W Mono N-Type Rigid Solar Panel goes from 22.3 V on its label to about 24.4 V at 20°F and 25.2 V at 0°F. The Power 1000 Mini accepts up to 28 V on the SDC (built-in MPPT, DJI MC4 solar cable).
Where to buy
We may earn a commission if you buy through these links. It never changes a verdict.
Other panels that work with the Power 1000 Mini
- DJI Power 1000 Mini: solar input 9 to 28 V on the Solar in (SDC (built-in MPPT, DJI MC4 solar cable)). DJI does not say whether this limit is open-circuit or working voltage, so we use the stricter reading: open-circuit voltage on your coldest morning.
- Cold raises panel voltage: we add 0.30% per °C below 77F (25°C), a typical figure, since this panel does not publish its own. At 20F one panel's 22.3 V becomes 24.4 V.
- The current limit for this input is not confirmed yet.
- Max 400 W on this input.
- Cold-morning voltage uses 0.30% per °C, typical for crystalline panels. This panel's own value is not published.
- Expected watts are the best case in full sun. Real-world midday output is usually 60 to 80% of that.