Will the EcoFlow 175W Rigid Solar Panel work with the DJI Power 1000 Mini?
Yes. One EcoFlow 175W Rigid Solar Panel works with the DJI Power 1000 Mini: about 27.9 V on a 20°F morning against the station's 28 V limit, and about 175 W in full sun. Two panels: works (2 panels in parallel on SDC (built-in MPPT, DJI MC4 solar cable)), about 350 W.
Works
1 x 175W Rigid Solar Panel into the Power 1000 Mini (1 panel on SDC (built-in MPPT, DJI MC4 solar cable)) stays inside 9 to 28 V, even at 20F.
- The brand does not say whether its voltage limit is open-circuit or working voltage, so we check against the stricter open-circuit number.
- The manual or page does not give a current limit for this input, so current was not checked.
- The MPPT is built in: panels connect to the SDC port with the DJI Power MC4 Solar Power Charging Cable. DJI gives the port as 9 to 28 V and 400 W but publishes no current limit, so the checker checks voltage and watts but not current.
- Not sold on the DJI US online store when we checked on Oct 28, 2026.
- EcoFlow's spec table labels the 7.85 A figure as a voltage; it is the operating current.
- Use the solar charging cable that came with the station (MC4 on the panel side).
175 W, open-circuit 25.5 V, short-circuit 8.3 A, working 22.3 V / 7.9 A. Brand page Panel details
DJI Power 1000 MiniSolar input SDC (built-in MPPT, DJI MC4 solar cable): 9 to 28 V, 400 W max. Brand page Station details
Change the count or temperatureTwo panels: every way to wire them
| Wiring | Input | Volts at 20F | Amps | Watts | Verdict |
|---|---|---|---|---|---|
| 2 panels in parallel on SDC (built-in MPPT, DJI MC4 solar cable) The brand does not say whether its voltage limit is open-circuit or working voltage, so we check against the stricter open-circuit number. | SDC (built-in MPPT, DJI MC4 solar cable) | 27.9 | 15.7 | 350 | Works |
| 2 panels in series on SDC (built-in MPPT, DJI MC4 solar cable) Open-circuit voltage 51V is above the station's 28V limit. Going over a station's input voltage limit can damage it. | SDC (built-in MPPT, DJI MC4 solar cable) | 55.8 | 7.9 | 0 | Don't connect |
Quick answers
Will the EcoFlow 175W Rigid Solar Panel work with the DJI Power 1000 Mini?
Yes. One EcoFlow 175W Rigid Solar Panel works with the DJI Power 1000 Mini: about 27.9 V on a 20°F morning against the station's 28 V limit, and about 175 W in full sun. Two panels: works (2 panels in parallel on SDC (built-in MPPT, DJI MC4 solar cable)), about 350 W.
Can I connect two 175W Rigid Solar Panel panels to the Power 1000 Mini?
Yes, 2 panels in parallel on SDC (built-in MPPT, DJI MC4 solar cable). That gives about 350 W.
What cable do I need to connect the 175W Rigid Solar Panel to the Power 1000 Mini?
Use the solar charging cable that came with the station (MC4 on the panel side).
Is it safe on a cold morning?
Panel voltage rises in the cold. One 175W Rigid Solar Panel goes from 25.5 V on its label to about 27.9 V at 20°F and 28.8 V at 0°F. The Power 1000 Mini accepts up to 28 V on the SDC (built-in MPPT, DJI MC4 solar cable).
Where to buy
We may earn a commission if you buy through these links. It never changes a verdict.
Other panels that work with the Power 1000 Mini
- DJI Power 1000 Mini: solar input 9 to 28 V on the Solar in (SDC (built-in MPPT, DJI MC4 solar cable)). DJI does not say whether this limit is open-circuit or working voltage, so we use the stricter reading: open-circuit voltage on your coldest morning.
- Cold raises panel voltage: we add 0.30% per °C below 77F (25°C), a typical figure, since this panel does not publish its own. At 20F one panel's 25.5 V becomes 27.9 V.
- The current limit for this input is not confirmed yet.
- Max 400 W on this input.
- Cold-morning voltage uses 0.30% per °C, typical for crystalline panels. This panel's own value is not published.
- Expected watts are the best case in full sun. Real-world midday output is usually 60 to 80% of that.