Will the Rich Solar MEGA 200 work with the BLUETTI Elite 30 V2?
Yes. One Rich Solar MEGA 200 works with the BLUETTI Elite 30 V2: about 23.9 V on a 20°F morning against the station's 28 V limit, and about 184 W in full sun. Two panels: works (2 panels in parallel on Solar input), about 184 W.
Works
1 x MEGA 200 into the Elite 30 V2 (1 panel on Solar input) stays inside 12 to 28 V, even at 20F. The station caps the current at 10 A.
- The panels can push 10.9A but this input takes 10A, so the station caps it. Safe, you just lose some watts.
- Use the solar charging cable that came with the station (MC4 on the panel side).
200 W, open-circuit 21.8 V, short-circuit 11.6 A, working 18.4 V / 10.9 A. Brand page Panel details
BLUETTI Elite 30 V2Solar input Solar input: 12 to 28 V, 200 W max. Brand page Station details
Change the count or temperatureTwo panels: every way to wire them
| Wiring | Input | Volts at 20F | Amps | Watts | Verdict |
|---|---|---|---|---|---|
| 2 panels in parallel on Solar input The panels can push 21.8A but this input takes 10A, so the station caps it. Safe, you just lose some watts. | Solar input | 23.9 | 21.8 | 184 | Works |
| 2 panels in series on Solar input Open-circuit voltage 43.6V is above the station's 28V limit. Going over a station's input voltage limit can damage it. | Solar input | 47.7 | 10.9 | 0 | Don't connect |
Quick answers
Will the Rich Solar MEGA 200 work with the BLUETTI Elite 30 V2?
Yes. One Rich Solar MEGA 200 works with the BLUETTI Elite 30 V2: about 23.9 V on a 20°F morning against the station's 28 V limit, and about 184 W in full sun. Two panels: works (2 panels in parallel on Solar input), about 184 W.
Can I connect two MEGA 200 panels to the Elite 30 V2?
Yes, 2 panels in parallel on Solar input. That gives about 184 W.
What cable do I need to connect the MEGA 200 to the Elite 30 V2?
Use the solar charging cable that came with the station (MC4 on the panel side).
Is it safe on a cold morning?
Panel voltage rises in the cold. One MEGA 200 goes from 21.8 V on its label to about 23.9 V at 20°F and 24.6 V at 0°F. The Elite 30 V2 accepts up to 28 V on the Solar input.
Where to buy
We may earn a commission if you buy through these links. It never changes a verdict.
Other panels that work with the Elite 30 V2
- BLUETTI Elite 30 V2: solar input 12 to 28 V on the Solar in (Solar input). BLUETTI sets this limit on open-circuit voltage (Voc), so we hold the panels' Voc on your coldest morning to it.
- Cold raises panel voltage: we add 0.30% per °C below 77F (25°C), a typical figure, since this panel does not publish its own. At 20F one panel's 21.8 V becomes 23.9 V.
- Current over the 10 A cap is safe: the station takes 10 A and you get fewer watts. We count only the capped watts.
- Max 200 W on this input.
- Cold-morning voltage uses 0.30% per °C, typical for crystalline panels. This panel's own value is not published.
- Expected watts are the best case in full sun. Real-world midday output is usually 60 to 80% of that.