Will the BLUETTI PV120 Solar Panel work with the BLUETTI Elite 30 V2?
Yes. One BLUETTI PV120 Solar Panel works with the BLUETTI Elite 30 V2: about 26.7 V on a 20°F morning against the station's 28 V limit, and about 120 W in full sun. Two panels: works (2 panels in parallel on Solar input), about 196 W.
Works
1 x PV120 Solar Panel into the Elite 30 V2 (1 panel on Solar input) stays inside 12 to 28 V and under 10 A, even at 20F.
- Use the solar charging cable that came with the station (MC4 on the panel side).
120 W, open-circuit 24.4 V, short-circuit 6.4 A, working 19.6 V / 6.1 A. Brand page Panel details
BLUETTI Elite 30 V2Solar input Solar input: 12 to 28 V, 200 W max. Brand page Station details
Change the count or temperatureTwo panels: every way to wire them
| Wiring | Input | Volts at 20F | Amps | Watts | Verdict |
|---|---|---|---|---|---|
| 2 panels in parallel on Solar input The panels can push 12.2A but this input takes 10A, so the station caps it. Safe, you just lose some watts. | Solar input | 26.7 | 12.2 | 196 | Works |
| 2 panels in series on Solar input Open-circuit voltage 48.8V is above the station's 28V limit. Going over a station's input voltage limit can damage it. | Solar input | 53.4 | 6.1 | 0 | Don't connect |
Quick answers
Will the BLUETTI PV120 Solar Panel work with the BLUETTI Elite 30 V2?
Yes. One BLUETTI PV120 Solar Panel works with the BLUETTI Elite 30 V2: about 26.7 V on a 20°F morning against the station's 28 V limit, and about 120 W in full sun. Two panels: works (2 panels in parallel on Solar input), about 196 W.
Can I connect two PV120 Solar Panel panels to the Elite 30 V2?
Yes, 2 panels in parallel on Solar input. That gives about 196 W.
What cable do I need to connect the PV120 Solar Panel to the Elite 30 V2?
Use the solar charging cable that came with the station (MC4 on the panel side).
Is it safe on a cold morning?
Panel voltage rises in the cold. One PV120 Solar Panel goes from 24.4 V on its label to about 26.7 V at 20°F and 27.5 V at 0°F. The Elite 30 V2 accepts up to 28 V on the Solar input.
Where to buy
We may earn a commission if you buy through these links. It never changes a verdict.
Other panels that work with the Elite 30 V2
- BLUETTI Elite 30 V2: solar input 12 to 28 V on the Solar in (Solar input). BLUETTI sets this limit on open-circuit voltage (Voc), so we hold the panels' Voc on your coldest morning to it.
- Cold raises panel voltage: we add 0.30% per °C below 77F (25°C), a typical figure, since this panel does not publish its own. At 20F one panel's 24.4 V becomes 26.7 V.
- Current over the 10 A cap is safe: the station takes 10 A and you get fewer watts. We count only the capped watts.
- Max 200 W on this input.
- Cold-morning voltage uses 0.30% per °C, typical for crystalline panels. This panel's own value is not published.
- Expected watts are the best case in full sun. Real-world midday output is usually 60 to 80% of that.