Will the BLUETTI SP100L Solar Panel work with the BLUETTI Elite 100 mini?
Yes. One BLUETTI SP100L Solar Panel works with the BLUETTI Elite 100 mini: about 27 V on a 20°F morning against the station's 60 V limit, and about 100 W in full sun. Two panels: works (2 panels in parallel on DC input), about 200 W.
Works
1 x SP100L Solar Panel into the Elite 100 mini (1 panel on DC input) stays inside 12 to 60 V and under 10 A, even at 20F.
- Use the solar charging cable that came with the station (MC4 on the panel side).
100 W, open-circuit 24.6 V, short-circuit 5.1 A, working 20.5 V / 4.9 A. Manual Panel details
BLUETTI Elite 100 miniSolar input DC input: 12 to 60 V, 350 W max. Brand page Station details
Change the count or temperatureTwo panels: every way to wire them
| Wiring | Input | Volts at 20F | Amps | Watts | Verdict |
|---|---|---|---|---|---|
| 2 panels in parallel on DC input Best option | DC input | 27 | 9.8 | 200 | Works |
| 2 panels in series on DC input | DC input | 53.9 | 4.9 | 200 | Works |
Quick answers
Will the BLUETTI SP100L Solar Panel work with the BLUETTI Elite 100 mini?
Yes. One BLUETTI SP100L Solar Panel works with the BLUETTI Elite 100 mini: about 27 V on a 20°F morning against the station's 60 V limit, and about 100 W in full sun. Two panels: works (2 panels in parallel on DC input), about 200 W.
Can I connect two SP100L Solar Panel panels to the Elite 100 mini?
Yes, 2 panels in parallel on DC input. That gives about 200 W.
What cable do I need to connect the SP100L Solar Panel to the Elite 100 mini?
Use the solar charging cable that came with the station (MC4 on the panel side).
Is it safe on a cold morning?
Panel voltage rises in the cold. One SP100L Solar Panel goes from 24.6 V on its label to about 27 V at 20°F and 27.8 V at 0°F. The Elite 100 mini accepts up to 60 V on the DC input.
Where to buy
We may earn a commission if you buy through these links. It never changes a verdict.
Other panels that work with the Elite 100 mini
- BLUETTI Elite 100 mini: solar input 12 to 60 V on the Solar in (DC input). BLUETTI sets this limit on open-circuit voltage (Voc), so we hold the panels' Voc on your coldest morning to it.
- Cold raises panel voltage: we add 0.30% per °C below 77F (25°C), a typical figure, since this panel does not publish its own. At 20F one panel's 24.6 V becomes 27 V.
- Current over the 10 A cap is safe: the station takes 10 A and you get fewer watts. We count only the capped watts.
- Max 350 W on this input.
- Cold-morning voltage uses 0.30% per °C, typical for crystalline panels. This panel's own value is not published.
- Expected watts are the best case in full sun. Real-world midday output is usually 60 to 80% of that.