Will the EcoFlow 175W Rigid Solar Panel work with the BLUETTI EB70S?
Yes. One EcoFlow 175W Rigid Solar Panel works with the BLUETTI EB70S: about 27.9 V on a 20°F morning against the station's 28 V limit, and about 175 W in full sun. Two panels: works (2 panels in parallel on Solar input), about 178 W.
Works
1 x 175W Rigid Solar Panel into the EB70S (1 panel on Solar input) stays inside 12 to 28 V and under 8 A, even at 20F.
- EcoFlow's spec table labels the 7.85 A figure as a voltage; it is the operating current.
- Use the solar charging cable that came with the station (MC4 on the panel side).
175 W, open-circuit 25.5 V, short-circuit 8.3 A, working 22.3 V / 7.9 A. Brand page Panel details
BLUETTI EB70SSolar input Solar input: 12 to 28 V, 200 W max. Brand page Station details
Change the count or temperatureTwo panels: every way to wire them
| Wiring | Input | Volts at 20F | Amps | Watts | Verdict |
|---|---|---|---|---|---|
| 2 panels in parallel on Solar input The panels can push 15.7A but this input takes 8A, so the station caps it. Safe, you just lose some watts. | Solar input | 27.9 | 15.7 | 178 | Works |
| 2 panels in series on Solar input Open-circuit voltage 51V is above the station's 28V limit. Going over a station's input voltage limit can damage it. | Solar input | 55.8 | 7.9 | 0 | Don't connect |
Quick answers
Will the EcoFlow 175W Rigid Solar Panel work with the BLUETTI EB70S?
Yes. One EcoFlow 175W Rigid Solar Panel works with the BLUETTI EB70S: about 27.9 V on a 20°F morning against the station's 28 V limit, and about 175 W in full sun. Two panels: works (2 panels in parallel on Solar input), about 178 W.
Can I connect two 175W Rigid Solar Panel panels to the EB70S?
Yes, 2 panels in parallel on Solar input. That gives about 178 W.
What cable do I need to connect the 175W Rigid Solar Panel to the EB70S?
Use the solar charging cable that came with the station (MC4 on the panel side).
Is it safe on a cold morning?
Panel voltage rises in the cold. One 175W Rigid Solar Panel goes from 25.5 V on its label to about 27.9 V at 20°F and 28.8 V at 0°F. The EB70S accepts up to 28 V on the Solar input.
Where to buy
We may earn a commission if you buy through these links. It never changes a verdict.
Other panels that work with the EB70S
- BLUETTI EB70S: solar input 12 to 28 V on the Solar in (Solar input). BLUETTI sets this limit on open-circuit voltage (Voc), so we hold the panels' Voc on your coldest morning to it.
- Cold raises panel voltage: we add 0.30% per °C below 77F (25°C), a typical figure, since this panel does not publish its own. At 20F one panel's 25.5 V becomes 27.9 V.
- Current over the 8 A cap is safe: the station takes 8 A and you get fewer watts. We count only the capped watts.
- Max 200 W on this input.
- Cold-morning voltage uses 0.30% per °C, typical for crystalline panels. This panel's own value is not published.
- Expected watts are the best case in full sun. Real-world midday output is usually 60 to 80% of that.