Will the BLUETTI PV350D work with the BLUETTI EB3A?
No. Open-circuit voltage 33V is above the station's 28V limit. Going over a station's input voltage limit can damage it. Two panels: don't connect (2 panels in parallel on Solar input), about 0 W.
Don't connect
Do not plug this in. Open-circuit voltage 33V is above the station's 28V limit. Going over a station's input voltage limit can damage it.
- Open-circuit voltage 33V is above the station's 28V limit. Going over a station's input voltage limit can damage it.
- The panels can push 12.7A but this input takes 8.5A, so the station caps it. Safe, you just lose some watts.
350 W, open-circuit 33 V, short-circuit 13.8 A, working 27.6 V / 12.7 A. Manual Panel details
BLUETTI EB3ASolar input Solar input: 12 to 28 V, 200 W max. Brand page Station details
Change the count or temperatureTwo panels: every way to wire them
| Wiring | Input | Volts at 20F | Amps | Watts | Verdict |
|---|---|---|---|---|---|
| 2 panels in parallel on Solar input Open-circuit voltage 33V is above the station's 28V limit. Going over a station's input voltage limit can damage it. | Solar input | 36.1 | 25.4 | 0 | Don't connect |
| 2 panels in series on Solar input Open-circuit voltage 66V is above the station's 28V limit. Going over a station's input voltage limit can damage it. | Solar input | 72.3 | 12.7 | 0 | Don't connect |
Quick answers
Will the BLUETTI PV350D work with the BLUETTI EB3A?
No. Open-circuit voltage 33V is above the station's 28V limit. Going over a station's input voltage limit can damage it. Two panels: don't connect (2 panels in parallel on Solar input), about 0 W.
Can I connect two PV350D panels to the EB3A?
No: Open-circuit voltage 33V is above the station's 28V limit. Going over a station's input voltage limit can damage it.
Is it safe on a cold morning?
Panel voltage rises in the cold. One PV350D goes from 33 V on its label to about 36.1 V at 20°F and 37.2 V at 0°F. The EB3A accepts up to 28 V on the Solar input.
Where to buy
We may earn a commission if you buy through these links. It never changes a verdict.
Other panels that work with the EB3A
- BLUETTI EB3A: solar input 12 to 28 V on the Solar in (Solar input). BLUETTI sets this limit on open-circuit voltage (Voc), so we hold the panels' Voc on your coldest morning to it.
- Cold raises panel voltage: we add 0.30% per °C below 77F (25°C), a typical figure, since this panel does not publish its own. At 20F one panel's 33 V becomes 36.1 V.
- Current over the 8.5 A cap is safe: the station takes 8.5 A and you get fewer watts. We count only the capped watts.
- Max 200 W on this input.
- Cold-morning voltage uses 0.30% per °C, typical for crystalline panels. This panel's own value is not published.
- Expected watts are the best case in full sun. Real-world midday output is usually 60 to 80% of that.