Will the BLUETTI PV350D work with the BLUETTI Pioneer MD (AC180T)?
Yes. One BLUETTI PV350D works with the BLUETTI Pioneer MD (AC180T): about 36.1 V on a 20°F morning against the station's 60 V limit, and about 276 W in full sun. Two panels: works (2 panels in parallel on Solar input (XT60)), about 276 W.
Works
1 x PV350D into the Pioneer MD (AC180T) (1 panel on Solar input (XT60)) stays inside 12 to 60 V, even at 20F. The station caps the current at 10 A.
- The panels can push 12.7A but this input takes 10A, so the station caps it. Safe, you just lose some watts.
- The panel's plug type is not confirmed yet. Check the label or the box before buying a cable.
350 W, open-circuit 33 V, short-circuit 13.8 A, working 27.6 V / 12.7 A. Manual Panel details
BLUETTI Pioneer MD (AC180T)Solar input Solar input (XT60): 12 to 60 V, 500 W max. Manual Station details
Change the count or temperatureTwo panels: every way to wire them
| Wiring | Input | Volts at 20F | Amps | Watts | Verdict |
|---|---|---|---|---|---|
| 2 panels in parallel on Solar input (XT60) The panels can push 25.4A but this input takes 10A, so the station caps it. Safe, you just lose some watts. | Solar input (XT60) | 36.1 | 25.4 | 276 | Works |
| 2 panels in series on Solar input (XT60) Open-circuit voltage 66V is above the station's 60V limit. Going over a station's input voltage limit can damage it. | Solar input (XT60) | 72.3 | 12.7 | 0 | Don't connect |
Quick answers
Will the BLUETTI PV350D work with the BLUETTI Pioneer MD (AC180T)?
Yes. One BLUETTI PV350D works with the BLUETTI Pioneer MD (AC180T): about 36.1 V on a 20°F morning against the station's 60 V limit, and about 276 W in full sun. Two panels: works (2 panels in parallel on Solar input (XT60)), about 276 W.
Can I connect two PV350D panels to the Pioneer MD (AC180T)?
Yes, 2 panels in parallel on Solar input (XT60). That gives about 276 W.
What cable do I need to connect the PV350D to the Pioneer MD (AC180T)?
The panel's plug type is not confirmed yet. Check the label or the box before buying a cable.
Is it safe on a cold morning?
Panel voltage rises in the cold. One PV350D goes from 33 V on its label to about 36.1 V at 20°F and 37.2 V at 0°F. The Pioneer MD (AC180T) accepts up to 60 V on the Solar input (XT60).
Where to buy
We may earn a commission if you buy through these links. It never changes a verdict.
Other panels that work with the Pioneer MD (AC180T)
- BLUETTI Pioneer MD (AC180T): solar input 12 to 60 V on the Solar in (Solar input (XT60)). BLUETTI sets this limit on open-circuit voltage (Voc), so we hold the panels' Voc on your coldest morning to it.
- Cold raises panel voltage: we add 0.30% per °C below 77F (25°C), a typical figure, since this panel does not publish its own. At 20F one panel's 33 V becomes 36.1 V.
- Current over the 10 A cap is safe: the station takes 10 A and you get fewer watts. We count only the capped watts.
- Max 500 W on this input.
- Cold-morning voltage uses 0.30% per °C, typical for crystalline panels. This panel's own value is not published.
- Expected watts are the best case in full sun. Real-world midday output is usually 60 to 80% of that.