Will the Rich Solar MEGA 200 PRO FLEX (24V) work with the Anker SOLIX C2000 Gen 2?
Yes. One Rich Solar MEGA 200 PRO FLEX (24V) works with the Anker SOLIX C2000 Gen 2: about 44.7 V on a 20°F morning against the station's 60 V limit, and about 200 W in full sun. Two panels: works (2 panels in parallel on Solar input), about 400 W.
Works
1 x MEGA 200 PRO FLEX (24V) into the C2000 Gen 2 (1 panel on Solar input) stays inside 11 to 60 V and under 17 A, even at 20F.
- The brand does not say whether its voltage limit is open-circuit or working voltage, so we check against the stricter open-circuit number.
- Anker does not say whether its voltage limit is open-circuit or working voltage, so the checker uses the stricter reading.
- A 24 V panel: 40.8 V open circuit on its own, so two in series only suit high-voltage solar inputs.
- Use the solar charging cable that came with the station (MC4 on the panel side).
200 W, open-circuit 40.8 V, short-circuit 6.2 A, working 34.2 V / 5.9 A. Brand page Panel details
Anker SOLIX C2000 Gen 2Solar input Solar input: 11 to 60 V, 800 W max. Brand page Station details
Change the count or temperatureTwo panels: every way to wire them
| Wiring | Input | Volts at 20F | Amps | Watts | Verdict |
|---|---|---|---|---|---|
| 2 panels in parallel on Solar input The brand does not say whether its voltage limit is open-circuit or working voltage, so we check against the stricter open-circuit number. | Solar input | 44.7 | 11.7 | 400 | Works |
| 2 panels in series on Solar input Open-circuit voltage 81.6V is above the station's 60V limit. Going over a station's input voltage limit can damage it. | Solar input | 89.4 | 5.9 | 0 | Don't connect |
Quick answers
Will the Rich Solar MEGA 200 PRO FLEX (24V) work with the Anker SOLIX C2000 Gen 2?
Yes. One Rich Solar MEGA 200 PRO FLEX (24V) works with the Anker SOLIX C2000 Gen 2: about 44.7 V on a 20°F morning against the station's 60 V limit, and about 200 W in full sun. Two panels: works (2 panels in parallel on Solar input), about 400 W.
Can I connect two MEGA 200 PRO FLEX (24V) panels to the C2000 Gen 2?
Yes, 2 panels in parallel on Solar input. That gives about 400 W.
What cable do I need to connect the MEGA 200 PRO FLEX (24V) to the C2000 Gen 2?
Use the solar charging cable that came with the station (MC4 on the panel side).
Is it safe on a cold morning?
Panel voltage rises in the cold. One MEGA 200 PRO FLEX (24V) goes from 40.8 V on its label to about 44.7 V at 20°F and 46 V at 0°F. The C2000 Gen 2 accepts up to 60 V on the Solar input.
Where to buy
We may earn a commission if you buy through these links. It never changes a verdict.
Other panels that work with the C2000 Gen 2
- Anker SOLIX C2000 Gen 2: solar input 11 to 60 V on the Solar in (Solar input). Anker SOLIX does not say whether this limit is open-circuit or working voltage, so we use the stricter reading: open-circuit voltage on your coldest morning.
- Cold raises panel voltage: we add 0.30% per °C below 77F (25°C), a typical figure, since this panel does not publish its own. At 20F one panel's 40.8 V becomes 44.7 V.
- Current over the 17 A cap is safe: the station takes 17 A and you get fewer watts. We count only the capped watts.
- Max 800 W on this input.
- Cold-morning voltage uses 0.30% per °C, typical for crystalline panels. This panel's own value is not published.
- Expected watts are the best case in full sun. Real-world midday output is usually 60 to 80% of that.