Will the Renogy 100W Lightweight Flexible Solar Panel work with the Anker SOLIX C2000 Gen 2?
Yes. One Renogy 100W Lightweight Flexible Solar Panel works with the Anker SOLIX C2000 Gen 2: about 24.6 V on a 20°F morning against the station's 60 V limit, and about 100 W in full sun. Two panels: works (2 panels in parallel on Solar input), about 200 W.
Works
1 x 100W Lightweight Flexible Solar Panel into the C2000 Gen 2 (1 panel on Solar input) stays inside 11 to 60 V and under 17 A, even at 20F.
- The brand does not say whether its voltage limit is open-circuit or working voltage, so we check against the stricter open-circuit number.
- Anker does not say whether its voltage limit is open-circuit or working voltage, so the checker uses the stricter reading.
- Use the solar charging cable that came with the station (MC4 on the panel side).
100 W, open-circuit 22.5 V, short-circuit 5.8 A, working 18.9 V / 5.3 A. Brand page Panel details
Anker SOLIX C2000 Gen 2Solar input Solar input: 11 to 60 V, 800 W max. Brand page Station details
Change the count or temperatureTwo panels: every way to wire them
| Wiring | Input | Volts at 20F | Amps | Watts | Verdict |
|---|---|---|---|---|---|
| 2 panels in parallel on Solar input The brand does not say whether its voltage limit is open-circuit or working voltage, so we check against the stricter open-circuit number. | Solar input | 24.6 | 10.6 | 200 | Works |
| 2 panels in series on Solar input The brand does not say whether its voltage limit is open-circuit or working voltage, so we check against the stricter open-circuit number. | Solar input | 49.3 | 5.3 | 200 | Works |
Quick answers
Will the Renogy 100W Lightweight Flexible Solar Panel work with the Anker SOLIX C2000 Gen 2?
Yes. One Renogy 100W Lightweight Flexible Solar Panel works with the Anker SOLIX C2000 Gen 2: about 24.6 V on a 20°F morning against the station's 60 V limit, and about 100 W in full sun. Two panels: works (2 panels in parallel on Solar input), about 200 W.
Can I connect two 100W Lightweight Flexible Solar Panel panels to the C2000 Gen 2?
Yes, 2 panels in parallel on Solar input. That gives about 200 W.
What cable do I need to connect the 100W Lightweight Flexible Solar Panel to the C2000 Gen 2?
Use the solar charging cable that came with the station (MC4 on the panel side).
Is it safe on a cold morning?
Panel voltage rises in the cold. One 100W Lightweight Flexible Solar Panel goes from 22.5 V on its label to about 24.6 V at 20°F and 25.4 V at 0°F. The C2000 Gen 2 accepts up to 60 V on the Solar input.
Where to buy
We may earn a commission if you buy through these links. It never changes a verdict.
Other panels that work with the C2000 Gen 2
- Anker SOLIX C2000 Gen 2: solar input 11 to 60 V on the Solar in (Solar input). Anker SOLIX does not say whether this limit is open-circuit or working voltage, so we use the stricter reading: open-circuit voltage on your coldest morning.
- Cold raises panel voltage: we add 0.30% per °C below 77F (25°C), a typical figure, since this panel does not publish its own. At 20F one panel's 22.5 V becomes 24.6 V.
- Current over the 17 A cap is safe: the station takes 17 A and you get fewer watts. We count only the capped watts.
- Max 800 W on this input.
- Cold-morning voltage uses 0.30% per °C, typical for crystalline panels. This panel's own value is not published.
- Expected watts are the best case in full sun. Real-world midday output is usually 60 to 80% of that.